MAKING MY 1ST BALL JOINT DOLL PART 4

Ball Joint Doll, Custom Dolls

So this is part 4 of my doll making process. In this post I will go over cutting open the head and torso. For anyone that might not know about ball jointed dolls the head, torso, arms and legs are hollow to allow for the stringing of elastic through the doll.

First I used my Dremel  hand drill to cut open the top of the head. Place a mark on the skull to make it easier to fit the two pieces back together. You don’t have to worry about being too neat as you will be putting the pieces back together. Once the top was removed I gently pushed the inside form away from the walls of the head until I could pull it out. I was left with a pretty consistent depth of clay around the form. At this point I carved out the initial shape of the eyes.

My next step is to hollow out the torso. I used my Dremel again to cut along the sides, shoulder, neck and bottom of torso. I finished off using my Exacto knife to separate any areas that I missed with the drill. Gently I pulled the two halves apart and removed the inner core. I was happy to find that it came apart fairly easily. In the next post I will cut the torso in half to give the doll more movement and I will add features to the face.

MAKING MY 1ST BALL JOINT DOLL PART 3

Ball Joint Doll, Custom Dolls

If you have been following these post welcome back and if you are just seeing this for the 1st time you might want to go back to part 1. I received the 2 packs of La Doll Premier stone clay that I ordered and began the process of building up the body and legs and also starting the head.

I have to say that after only working with it for a short time I really do prefer working with the Premier stone clay over the regular La Doll. I find that it is more pliable and easier to work with and sculpt. I added definition to both legs and built up the anatomy of the torso. I also added the first layer of clay to the head and pushed in the area where the eyes will go so it almost looks like a skull.

In part 4 I will be hollowing out the head and torso.

MAKING MY 1ST BALL JOINT DOLL PART 2

Ball Joint Doll, Custom Dolls

Here is part 2 of my ball joint doll project. I started with the body and legs using the straws and body form shown in part 1. I started off using La Doll stone clay and quickly realized that I would be needing way more than 1 pack of clay. After kneading and rolling out the clay to about a 1/4 inch depth I wrapped it around the body form and smoothed it out as best as I could. I found La Doll clay a little hard to work with even after a lot of kneading and misting with a water bottle. With the clay that I had left I repeated the process of rolling out the clay and I covered the the straws for the legs with a first layer of clay.

After doing a little more research and watching a few more videos I decided to try La Doll Premier stone clay as it was recommended for being smoother and more pliable. I have ordered 2 packs and will post more progress when they come in. I also ordered fine sand paper and a pack of metal files. I will continue in part 3.

2016-06-20 18.04.12